Want to retain the low end torque of the factory intake but increase your high end horsepower?
You NEED the Hughes Fuel Injected Intake for your 5.2L/5.9L Magnum engine.
This intake made by Edelbrock exclusively for Hughes Engines not only INCREASES Horsepower but will also improve your Mileage.
This kit comes with all brackets and mounting hardware needed to install on your engine.
Direct replacement for all emission controlled OBDII equipped Magnum trucks (Most 1996 and newer 5.2 or 5.9).
May require some modifications for earlier model ,OBD1 equipped vehicles, and would be for Off-road use only.
We get a lot of questions from people in California as to if this intake meets California emission standards.
According to the California Department of Consumer Affairs Smog Check Reference Guide we see no reason that our intake would not be compliant on all OBDII equipped vehicles. Based on the following text from the CARB website, the Hughes Engines FI AirGap intake is exempt from requiring CARB certification.
As quoted from California Department of Consumer Affairs Smog Check Reference Guide Appendix G , page G-7.
"For the purposes of Smog Check Inspection, the following parts and emissions control changes are acceptable provided that all of the required emission controls are connected and functioning. When conducting a Smog Check Inspection, it is not necessary to check for a CARB Executive Order for the following: “Any intake manifold that includes provisions for the OE emission controls (EGR, TAC, carburetor, thermal switches, choke stove, exhaust cross-over etc.) The manifold must be marketed by the manufacturer for street use on emission controlled vehicles”